|
|
|
|
Part Number: US-R6CFLBB2668
Wattage: 26w Input Voltage: MVOLT Bulb Type: Fluorescent Double Twin Tube - quad Bulb Base: Gx24q-3, 4-pin Ballast: Electronic
Length: 12.0" - 24.0" (305mm - 610mm) Width: 7" (178mm) Height: 7.25" (184.15mm)
1 year limited factory warranty
*Energy Star
Emergency Battery Pack (EMG 750): Emergency battery pack with remote test switch. Operates maximum single lamp 42W TRT or double lamp 32W TRT in emergency mode with battery backup in case of power failure.
- Transformer Type : Electronic
- Construction Type : New
- Dimmable : No
- Bar Hangers : 12" - 24" joist span, Connect w/out nails / screws, Fits T-bar spline, Pre-Installed
- Adjustable : Fixed
- Knockouts : 4 x 1/2", 4 x Romex
- Approval Type : UL, UL - Damp location, UL - Direct contact with insulation, UL - Feed-through wiring, C-UL - Damp location, C-UL - Direct contact with insulation, C-UL - Feed-through wiring
- Recessed Size : 6 Inch
- Length : 12.0" - 24.0" (305mm - 610mm)
- Height : 7.25" (184.15mm)
- Width : 7" (178mm)
|
|
|
|
|
|
|
|
|
|
|
|
|
Features
-
- HOUSING - Die formed aluminum construction for for maximum heat dissipation and rust protection. Adjusts vertically in plaster frame to accommodate 1/2" to 1-3/8" ceilings.
-
- SOCKET - One vertically mounted plug-in socket for PL lamp. Preinstalled on an adjustable mounting bracket to allow for proper and consistent lamp positioning.
-
- JUNCTION BOX - is ETL listed for through-branch circuit wiring and has four 1/2" KOs, one 3/4" KO and four Romex knockouts with true pry-out slots and strain clamps
-
- BALLAST - Thermally protected, current controlled electric ballast, will produce full light output, increase lamp life with no noise and flicker. Domestic brand ballast.
-
- AR HANGERS - Preinstalled bar hangers allow housing to be positioned and locked at any point within a 24" joist span. They can be used on either long or short axis of housing and can be shortened for 12" joists. They are designed to be hammered directly without using nails or screws and could be fit onto T-Bar spline for easy installation and quick alignment.
|
|
|
|
|
|
|