Home > Recessed Lighting Housings >

4" Shallow Electronic IC-AT Housing


Alternative Views:

Price: $96.10

Stock Status: In Stock

Description Technical Specs Shipping Time
Part Number: HBL4IC-E-S-AT

Small aperture low voltage, thermally protected IC rated, specification grade recessed shallow housing. Designed for new construction. Accommodates up to 35W MR16 lamps. Furnished with preinstalled adjustable bar hangers. Junction box is provided with four ½” KOs, one ¾” KO and four Romex knockouts with strain relief.
  • HOUSING - Die-formed aluminum construction for maximum heat dissipating air chamber on top of the housing. Junction box could be accessed from inside and outside housing.

  • INNER HOUSING - Deep-drawn single piece aluminum construction for maximum heat dissipation and rust protection. Adjusts vertically in plaster frame to accommodate ½” to 1-3/8” ceiling.

    TRANSFORMER - Enhanced in heat dissipating cover, to provide noise free operation. Attached to junction box cover so it may be serviced from below the ceiling. Thermally protected. E-Class II dimming electronic transformer, providing 35% more lumens than traditional transformers. Constructed of M3 grade silicone steel. (Must use dimmers rated for electromagnetic transformer)

    BAR HANGERS - Preinstalled bar hangers allow housing to be positioned and locked at any point within a 24” joist span and can be shortened for 12” joists. Integral bar hanger nailers are designed to be hammered directly into the joist without additional nails or screws and makes installation fast and accurate. Bar hangers can fit onto T-Bar spline with additional slots and holes for special mounting methods if necessary.

    JUNCTION BOX - ETL and UL listed for through-branch circuit wiring and has four ½” KOs, one ¾” KO and four Rome

    • Integral low voltage magnetic transformer to prolong lamp life and increase lighting quality.
    • Thermally Protected IC housing.
    • Designed for accent and task lighting applications.
    • Wire through junction box.
    • Preinstalled adjustable bar hangers.
    • Dependable, favorable design and effortless installation.
    • 7-1/4” height allows use in 2” x 8” joist construction.
    • Special screw on the frame locks bar hangers in place which prevents the housing from any movement once installed

  • Lighting Chart

    *Note: Not compatible with LED bulbs as they do not put enough load on the electronic transformer. Will cause premature failure.
    We do not recommend pre-cutting any holes until housings are on site.

Related Items
4" Stepped Baffle Trim - Regressed 4" Baffle Wall Wash - Regressed 4" Low Voltage Trim - Angle Cut Wall Wash Reflector 4" Eyeball Trim - Gimbal Ring
Price: $8.25

Price: $12.85

Price: $24.00

Price: $19.40

B1401W-WH | 4" Stepped Baffle Trim - Regressed | USALight.com B1416W | 4" Baffle Wall Wash - Regressed | USALight.com B1463W-WH | 4" Trim - Angle Cut Wall Wash Reflector | USALight.com B1461WH | 4" Eyeball Trim - Gimbal Ring | USALight.com

Share your knowledge of this product. Be the first to write a review »