 |
 |
 |
 |
|
 |
|
Features
Construction/Installation
▪ Single Wall New Construction Airtight Housing with Thermal Protector. Suitable for T-grid and drop ceiling applications.
▪ Housing adjusts in frame to accommodate up to 1 1/4" ceiling thickness. Airtight housing with gasket to restrict airflow in accordance with ASTM E-283 air-tight requirements.
▪ Lamp: 120V, MR16 GU10 LED (Not Included). Lamp Holder: Twist-and-lock MR16 GU10.
▪ Designed for ceiling plenums where 2x6 joists or taller are used. Steel housing for greater heat dissipation. Stamped Galvanized steel frame.
Junction Box
▪ Positioned to accommodate straight conduit runs. Junction box is accessible from below the ceiling.
▪ Seven (7) 1/2" trade size conduit knockouts, Four (4) 3/4" knockouts with pry-out knockout slots, Four (4) Romex pry-outs with strain relief.
▪ See installation sheet for detailed information
Hanger Bars / New Construction
▪ Pre-installed hanger bars with True Nail facilitate easy installation in regular lumber, engineered lumber, and laminated beams. Maximum Hole cutout is 4 1/4".
▪ Integral T-bar slots for easy installation in T-bars. Spans up to 24" and can be repositioned 90°. Score lines allow for tool-free hanger bar size reduction. Integral leveling flange allows for single-person installation while aligning the housing with joists.
Electrical
▪ Input Voltage: 120VAC. Thermally protected against improper lamping.
Dimmability
▪ Based on lamp selection.
Compatible Trims
▪ Compatible with - ELCO 4" MR16 Trims. Lamp: Designed for use with GU10 MR16 LED: Sold Separately!
Listing
▪ UL Listed for Damp Locations. UL Listed Wet Location with select trims.
▪ Airtight per ASTM E-283. Install a JA8-2016-E Lamp/Luminaire for Title 24 Compliance.
▪ UL Listed for Feed Through.
|
|
|
|
|
|
|
