 |
 |
 |
 |
|
 |
|
Features
Construction/Installation
▪ Single Wall IC Rated for direct contact with insulation, for use in IC and non-IC conditions.
▪ Housing adjusts in frame to accommodate up to 1 1/2" ceiling thickness. Airtight housing with gasket to restrict airflow in accordance with ASTM E-283 air-tight requirements.
▪ Lamp: 120V, MR16 GU10 LED (Not Included). Lamp Holder: Twist-and-Lock GU10 MR16 Lamp Holder. Steel Housing for greater heat dissipation.
▪ Designed for ceiling plenums where 2x6 joists or taller are used. Stamped Galvanized steel frame.
Junction Box
▪ Positioned to accommodate straight conduit runs.
▪ Seven (7) 1/2" trade size conduit knockouts, Four (4) 3/4" knockouts, Four (4) Romex pry-outs with strain relief.
▪ See installation sheet for detailed information
Hanger Bars / New Construction
▪ Pre-installed hanger bars with True Nail facilitate easy installation in regular lumber, engineered lumber, and laminated beams. Maximum Hole cutout is 4 1/4". Suitable for T-grid and drop ceiling applications.
▪ Integral T-bar slots for easy installation in T-bars. Spans up to 24" and can be repositioned 90°. Score lines allow for tool-free hanger bar size reduction. Integral leveling flange allows for single-person installation while aligning the housing with joists.
Electrical
▪ Voltage: 277VAC with 277V to 120V Step-Down Transformer. Thermally protected against improper lamping.
Dimmability
▪ Based on lamp selection.
Compatible Trims
▪ Compatible with - ELCO 4" MR16 Trims. Lamp: Designed for use with GU10 MR16 LED: Sold Separately!
Listing
▪ UL Listed for Damp Locations. UL Listed Wet Location with select trims, UL Listed for Feed Through
▪ Airtight per ASTM E-283. Install a JA8-2016-E Lamp/Luminaire for Title 24 Compliance
▪ UL Listed for Direct Contact with Insulation and Combustible Materials.
|
|
|
|
|
|
|
